+39 02 90 90 134 [email protected]

Basic Angle Control

Basic Angle Control

All the Of.me.r. Bending and Combined machines allow the bending angles setting through two pins inserted in the holes of the turning plate, one in the zero point and the other to determine the angle amplitude.
This operation is manual and the position of the second pin is to be modified whenever it is necessary to change the angle. In the case of a cyclical and continuous stirrup production this can slow down the times of production.

For this reason Of.me.r. is proud to present the Basic Angle Control, a special electronic card able to memorize with a simple operation up to 6 bending angles in sequence, that is able to manage the functionality of the limit switches and also record the working times. All this without any additional cost!

Need Help? Contact Us Leave Feedback

Share

The Basic Angle Control electronic card could be mounted on all the threephase Bending and Combined machines. It is supplied, on request in phase of order, as a free accessory.

This electrical panel offers the possibility to work in the automatic mode, using therefore the memorized angles, or manually, through the use of the pins. This gives to the operator the freedom of use according to the requirement and the kind of operation to be done.
For these reasons, the Basic Angle Control is particularly suitable for small construction sites with an occasional production of stirrups.

Electrical Panel with Basic Angle Control